Centerfire Barrel Assembly

Knight Articles and Muzzleloader Manuals Can Be Found Here.
knightrifles
Site Admin
Posts: 75
Joined: January 17th, 2012, 11:53 am

Centerfire Barrel Assembly

Postby knightrifles » October 1st, 2018, 2:30 pm

Turn the rifle slightly to its side with one hand and with the other align the pivot pin hole of the weld lug with the pivot pin hole of the receiver.

Once the holes are aligned, push the pivot pin through until flush with both sides of the receiver

While holding the receiver and buttstock with the action open and the breach exposed. Grip the extractor with the thumb and index finger, align the flat screwdriver end of the extractor with the extractor retaining slot, and firmly push forward. The extractor should be held in firmly while moving forward under tension from the extractor assist spring. Close the action (note the action should close with reasonable tension)

Replace the forearm by placing the wings in the rear first and, with an upward motion, locking the forearm in place. The forearm will be held firmly to your rifle while free floating.

Knight Rifles, American Made muzzleloaders.

Who is online

Users browsing this forum: No registered users and 1 guest