Page 1 of 1
Adjusting Trigger Pull
Posted: October 9th, 2015, 2:36 pm
by bassbucks
I adjusted the trigger pull slightly making it lighter and in doing so it caused the flit safety to stop working. Anyone know why and how to fix it?
Thanks,
Bass
Re: Adjusting Trigger Pull
Posted: October 9th, 2015, 5:33 pm
by a1smokepole
Do you have the trigger with the two screws on the front of the trigger and one on the back.
Re: Adjusting Trigger Pull
Posted: October 9th, 2015, 7:20 pm
by bassbucks
Yes.
Also I was just now reading the manual and it said to only send the trigger in to Knight to have it adjuster.
Thanks,
Bass
Re: Adjusting Trigger Pull
Posted: October 10th, 2015, 9:13 am
by bassbucks
Let's try tat again.
Yes.
Also I was just now reading the manual and it said to only send the trigger to Knight to have it adjusted.
There.....that's better.
Bass
Re: Adjusting Trigger Pull
Posted: October 10th, 2015, 2:39 pm
by a1smokepole
Every time you adjust the trigger weight you have to adjust backlash don't touch the back screw sear adjustment. 1 front bottom screw first you screw out to lighting trigger weight. 2 then the top front screw is backlash you screw this all the way in then depress the trigger and slowly start to screw out on the backlash screw tell the trigger goes off stop check trigger weight and see if its were you what it. not there start over. I would not go under 2 LBS