info on breechplug
what size drillbit do I need to use to clean the flashhole, and make sure its adequate to use with Blackhorn 209 powder. Thanks, Buck
- sabotloader
- Posts:197
- Joined:February 22nd, 2012, 11:07 pm
Re: info on breechplug
Assuming you are talking about a older version Knight breech plug, you would need a 1/8" drill bit to clean the flash channel. Hand turn the bit from the primer end of the breech plug. I make a little gadet called a 'bit on a stick' - this way I can spin clean the flash channel with the BP in the rifle at the range.arbuck wrote:what size drillbit do I need to use to clean the flashhole, and make sure its adequate to use with Blackhorn 209 powder. Thanks, Buck
Also remember you are cleaning the 'flash channel' not the flash hole, it will take care of itself.
Here is a homemade drawing I did showing the different names. I did this to help explain another topic but it should also work here.
If you have a new version Knight Breech Plug you would need to use a 5/32" drill bit....
Remember turn by hand.
Keep on Shooting Muzzleloaders - They are a blast
Re: info on breechplug
have done this many times on many smokepoles. We have allways used 3/64. Problem solved!
Jay
Jay