LK93 Question

Post Reply
ko4nrbs
LK93 Question

Post by ko4nrbs » October 12th, 2016, 2:49 pm

I have an older LK93 54 caliber that I installed the 209 primer kit in. On the end of the breech mechanism is a small thumb screw. I found that it must be adjusted past the little RED circle or the primer will not ignite. At the range I adjusted it out so it would ignite the 209 bit not pierce it. Is this all you do or is there a certain number of threads you must count as you back it out?

Bill

a1smokepole
Posts:202
Joined:February 23rd, 2012, 6:29 pm
Location:Mandeville La.

Re: LK93 Question

Post by a1smokepole » October 12th, 2016, 7:02 pm

You just screw it out all the way tell it stops.

ko4nrbs

Re: LK93 Question

Post by ko4nrbs » October 12th, 2016, 7:06 pm

Thank you!!

I finally found a video of it to.
https://www.youtube.com/watch?v=hFYS1jVrQ24

Bill