Page 1 of 1

LK93 Question

Posted: October 12th, 2016, 2:49 pm
by ko4nrbs
I have an older LK93 54 caliber that I installed the 209 primer kit in. On the end of the breech mechanism is a small thumb screw. I found that it must be adjusted past the little RED circle or the primer will not ignite. At the range I adjusted it out so it would ignite the 209 bit not pierce it. Is this all you do or is there a certain number of threads you must count as you back it out?

Bill

Re: LK93 Question

Posted: October 12th, 2016, 7:02 pm
by a1smokepole
You just screw it out all the way tell it stops.

Re: LK93 Question

Posted: October 12th, 2016, 7:06 pm
by ko4nrbs
Thank you!!

I finally found a video of it to.
https://www.youtube.com/watch?v=hFYS1jVrQ24

Bill